Open 65 extruder how to save electricity

Today's price is higher and higher, we should also be calculated in the use of equipment.

How to open 65 extruder to save electricity? Now, energy saving, environmental protection of the subject we are concerned, and also great attention by the government, so at runtime, an enterprise how to save electricity is also very important.

65 extruder is known to all that the commonly used rubber extrusion molding equipment, everyone should be familiar with, small make up think both twin screw and single screw extruder, they all before production products need to be heat engine startup process. So energy conservation province electricity this element is very necessary, so at the time of heat engine you considered this procedure can also power saving?

65 extruder on start heating process is open at the same time began to heat, the temperature of a few grade, of course, this method is commonly used, but it often after the temperature reaches a certain index of the screw, the temperature of the die head haven't reached (die the thick of the steel, the area is larger), so everyone in this case is generally to heat preservation of the screw, and the temperature of the die head slowly reaches the set temperature to boot, this approach is the most save electricity.

And, of course, on the one hand, it's important to note that on heating the boot is actually a simple successively heating can help you save a lot of electricity, specific how to do it, actually method is very simple. In several heating period heating at the same time, when the temperature of the screw when you begin to remember good time set temperature is reached, then such as die head temperature reaches set temperature remember once time, when there is a time gap, namely screw reaches the set temperature and the time gap between die reaches the set temperature is how many minutes? Find out the time difference, you at this time when starting up the Numbers in advance so long for the mould head heat, to achieve this time open the screw again after heating, it also can save electricity.

Above two ways to open 65 extruder compare save electricity, you know?