Metal corrugated pipe forming machine

Metal corrugated pipe forming machine is the production of prestressed concrete reserved channel of metal corrugated pipe equipment, its main characteristic is small volume, high efficiency, simple operation and maintenance, applicable to the construction site or factory production use.

Technical parameters

1, the main motor power: N = 3 kw N = 1430 rad/min

2, the strip width: b = 36 mm

3, the thickness of the steel strip: a = 0.25 ~ 0.3 mm

4, volume tube diameter range: 35 ~ 135 diameter

5, production speed: 35 ~ 65 diameter 4 m/min

Diameter of 70 ~ 135 m/min

6, cutting machine, electric power, N = 0.75 KW N = 1380 rad/min

Adjustment and operation

Metal corrugated pipe forming machine concrete operation steps, please refer to the northern video.

Finished goods inspection

After (1) pipe roll out, should check whether the pipe buckles, trimming, fracturing phenomenon, and cut off a tear pliers, buckles, fit check.

(2) check the finished product, the tear can use 400 mm long pipe steel belt buckles, one person pulls the pipe, one pliers pull steel belt, when opened, buckles, no tear, and check the ruffled, nondestructive tear phenomenon.

maintenance

1, 32, turbine reducer with machine oil, the oil level height should not be below the cursor scribed line.

2, main shaft with taper roller bearings, should adjust its clearance, make main shaft can turn easily, and no obvious loose, bearing place add grease on a regular basis.

3, spindle and molding head should not be the matching surface between the remaining oil, after stalling for a long time, every day in front of the boot, a bit of oil in helical surface and the shaft attaches, so as not to dry friction.

4, press pulsator by axial fixed round nut, should be to tighten the nut in order to avoid loose after repair.