What are the operation of the corrugated pipe forming machine

Corrugated pipe forming machine operating considerations, mainly summarized as follows:

A. Product placement process, the movement wants standard, in one hand and die, in one hand and product, fast group of assembled products into the cavity, the connector must be in place. (joint) or crushed

2. Line, wire into the cavity on the basis of 3 ~ 5 mm. (when molding in use)

3. Visual line is OK, can press the switch operation (operation) must be hands

4. Press the switch after the operation, hand and goods are not in the cavity, if you have found abnormal, please immediately press the emergency switch, the machine will automatically pick up. (operation panel middle button)

5. The machine in the process of setting the parameters of automatic operation, please do not arbitrarily collision machine switch and button.

Six. Molding products, take take on to prevent its deformation, in general, met a bad phenomenon, should right hand tight mould, left hand tight wire, gently upward, make good molding products nets tail first demoulding, then grasped mould out product, also can do some appropriate release agent.

7. To get into the habit of independent inspection in the process of operation, the technician debugging good machine, the computer operation, 15 die before, must first confirm, may continue to work, first, after confirm OK before an hour of homework to do key detection (appearance, electrical), etc.

Eight. Good molding products, to be neat, light to take light put, squeezing and collision